Outbacker RV Forum banner

120/240 Volt Ac, 30 Amp Receptacle

7K views 12 replies 6 participants last post by  GarethsDad 
#1 ·
I have a 10000W generator with a 120/240 Volt AC, 30 AMP receptacle. I have a 4 prong adapter that converts it to the 3 prong receptacle that a 30amp travel trailer would use. I don't really understand this receptacle. The manual says its for 120v or 240v use. How do you know if its putting out 120v or 240v? I don't want to fry everything in my camper by plugging it in to something putting out 240V. This is probably a stupid question to you electrical gurus out there so I apologize up front for a possibly dumb question but if anyone could help me I would greatly appreciate it.
 
See less See more
1
#2 ·
Help us out by reading the numbers on the face of the receptacle or posting a picture of it.
 
#4 ·
Your 4 round plug has 1 neutral, 1 ground, and 2 hot. For 240v you use both hot and for 120v you only one hot. Your adapter plug may only have 3 prongs using the neutral,ground and 1 hot or four prongs but only three wires to the neutral,ground and 1 hot. James
 
#5 · (Edited by Moderator)
On your generator do you have a selector switch for 120-240 vac?

You could also verify the adapter is wired to only take one of the hot legs.

The L shaped blade is ground
The blade opposite the ground is neutral
the other two are hot legs. If switched to 120 on the generator then both hots should be phased the same (voltage hot to hot will be zero). If switched to 240 then they will be phased 180 from each other (voltage hot to hot will be 240)
 
#6 ·
ok, I think I understand it now. The adapter plug you use either makes it a 120 or 240. My adapter plug says its for 120 30A service so the plug only allows 1 of the 2 120 v plugs to be active. Am i following you on this? So its ok to plug the camper into this adapter (which came from PPL camper parts and said it was for generator use for 120/30A service).

Ok, cool - thank you Garethsdad and CamperAndy for helping me out with this!
 
#7 ·
Sounds like you got it! Two hot 120 circuits would give you 240. As long as you use the 3 prong adapter, you should be good.
 
#10 · (Edited by Moderator)
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top