Looking at my rear king bed slide today, I noticed that it sloped a tad bit down at rear of slide. I started thinking, what supports the slide when it is out? Especially considering it is rated to 1000#. It looks like if you put 500#s on it, it would just bend and break off!!

We have a 2004 28RSS, We found the wall next to our front left bunk with bubbling wallpaper and the wall feels slightly mushy behind it mostly near the roof. We re cauked any suspect areas on the roof and bunk window but we dont know what to do about what seems like water damage to the wall...

I have a 2011 Outback 250RS. It has AL-KO T44 (4400# axles). I have read that these axles AND parts were discontinued after Dexter purchased AL-KO. So, now what? Parts are no longer available and there are NO cross over parts from Dexter. Are we now SOL? This is really depressing. I...

I am going through testing all trailer systems...refer on propane, heater, stove, oven. Two days ago I switched refer over to propane to let it run on propane and see if it would get colder than when on 120V. It did not. It actually was 1-2 degrees warmer! I tested stove, oven, and furnace...

I'm looking for some advice on blowouts. Over the weekend we had a bad one that ripped a hole in the floor. Then proceeded to tear out a some wiring which really looks worse then it is. When we bought it we we're told this had happened before. So apon further inspection I realized they had...