Outbacker RV Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I just bought a 240URS and it is pre-wired for a zamp solar system. Basically this means there are connectors on the roof for panels. My problem is that I have no clue where the connector's wires end up. I feel like I'm going to use Renogy solar and I'm trying to figure out where to install the charge controller. Even zamp doesn't seem to know. Any suggestions or pointers are much appreciated!
 

·
Registered
Joined
·
81 Posts
Looks like by the batteries, here’s a video and if you speed up to 5:00 into the video it shows where it’s located.
 

·
Registered
Joined
·
1 Posts
I just bought a 240URS and it is pre-wired for a zamp solar system. Basically this means there are connectors on the roof for panels. My problem is that I have no clue where the connector's wires end up. I feel like I'm going to use Renogy solar and I'm trying to figure out where to install the charge controller. Even zamp doesn't seem to know. Any suggestions or pointers are much appreciated!
You can either install it on your solar panel before plugging it into the zamp plug or put it behind that front facia.
 

·
Registered
Joined
·
10 Posts
Hi, We bought our 240URS in Oct of 2020. Finally put on solar in June 2021. We had the same issue. Pre-wired for solar but it wasn't identified where the charge controller is. A local RV shop found it in the right front compartment to the left of the light in the compartment on the forward bulkhead. Wires were short / tight coming from the batteries, just be advised. You may have to splice or run new longer wires. Bought Go Power panel (190W) and bluetooth charge controller. I did have to do a hard reset to get it to change from Lithium to Flooded on the app. Good luck.
 
1 - 4 of 4 Posts
Top